Restore the factory-set default settings
Follow these steps to restore the product's factory default settings. These steps do not reset page counts, service IDs, or other static product values.
CAUTION:These steps will reset the product's current wireless settings to factory-set default settings. Any custom settings will be lost, and you will need to reconfigure the product's wireless settings.
- Press the Power button to turn off the product.
- Press the Power button to turn on the product.
- The product begins to initialize.
While the product initializes, press and hold the Cancel button and the Wireless button (in this order) for 10 to 15 seconds (until it print a "Self Test / Device Configuration" page), and then release both buttons.
NOTE: LED lights blink until both buttons are released.
The factory default settings are restored.
Config Wireless Printer
- Connect to the Ad Hoc Printer Network
You should eddit the printer connection: "IPv4 Settings" -> "Method: Link-Local Only"
Maybe you have to "Disconect and Connect" until you can ping the printer.
To get the printer IP you have to print a "Self Test / Device Configuration" page (after connecting to the Ad Hoc Printer Network) and check it in: "Network Information" -> "IP Default Gateway" -> PRINTER_IP
Take in mind that the IP could change during the configuration.
- Once you are in the Printer Web-Interface, go to "Networking" and configure your wireless network.
Once it's configure and working, you should be able to ping the printer in your network.
- Install the last version of hplib (http://hplipopensource.com/)
In the installation process, when detecting the printer, selet de second option "Network/Ethernet/Wireless network (direct connection or JetDirect)" and the printer will be automatically detected.
More information:
http://h10025.www1.hp.com/ewfrf/wc/document?cc=us&dlc=en&docname=c02486112&lang=en&lc=en&product=4110396
http://h10032.www1.hp.com/ctg/Manual/c01695231.pdf
